This is an older standard, but is still widely used, especially on commercial IMO SOLAS vessels.Īs is immediately obvious from above diagrams, NMEA 0183 uses significantly more cabling to connect all devices. Older Marine Electronic Devices commonly have NMEA 0183 interfaces. Mid-Feed=2 backbone segments totally 100m Maximum Voltage Drop per Backbone recommended for higher backbone lengths and/or high LEN Maximum Number of NMEA 2000 Devices per NetworkĮquivalent Network Load for all devices (LEN) per Backbone Segment In addition, NMEA 2000 networks should be designed adhering to below rules.
All the required NMEA 2000 network parts can be supplied by Actisense via Lambda Marine.īackbone maximum cable length (terminator-to-terminator) Additional cable lengths can be used between any of the connectors to extend the length of the network, whilst ensuring that the NMEA 2000 rules for cable lengths are adhered to, see below “Table 1 - NMEA 2000 Cable Length Rules”. T-Pieces are needed to connect each device to the network. 2 x NMEA 2000 Devices (such as the Actisense EMU-1 and/or any other NMEA 2000 certified device from various manufacturers such as Radars, Chartplotters, GPS etc.).2 x T-Pieces (one per connected device).2 x Terminating Resistors (to terminate the network on both ends of the backbone).1 x Power-T (to insert network power, should be fused).
In addition, a correctly functioning network will require at the minimum the following components: